These instructions in .pdf (361 kb file)
Remove Bushing Housing from rear of Auger. Leave Auger in T-630.
Split the inside of bushing with a chisel. Tap bushing up and
out. Gently chisel around top of bearing to remove hardened
concrete. Lubricate bearing to free up.
Remove excess build up from inside (below left). Tapered Line up nose (below
center) may be found in bottom. It is no longer needed and may be
discarded. Clean shaft surface and re-use if possible.
Install New Bushing. An press actually works best.
Bushing
- Tucker Part # 80313
Last updated: July 10, 2007
Email Tucker Sales
Organization Name
P.O. Box 492810
Leesburg, FL 34749
Shipping:
Phone: (352) 787-3157
Fax: (352) 365-1732
Copyright © 2008
Organization Name All rights
reserved.